Not the v6 you were expecting, enter the BITIMBO (and attex, etc)

The Something Awful Forums > Discussion > Automotive Insanity > Not the v6 you were expecting, enter the BITIMBO (and attex, etc)

cursedshitbox: May 20, 2012; Your rear-end wont survive my hammering.; Fun Shoe

I wanna see what's behind the gauges

# ¿ May 10, 2019 15:38

Adbot: ADBOT LOVES YOU

# ¿ May 7, 2024 10:17

cursedshitbox: May 20, 2012; Your rear-end wont survive my hammering.; Fun Shoe

Darchangel posted:

Everyone says that, and I have yet to have seen that happen. Maybe it's a problem in aircraft and space vehicles, but there's a lot more dodgy bits in ground vehicles to worry about.
That said, a properly applied wire nut isn't really that terrible n the scheme of things. Way better than twist-n-tape, or even terminals if they are poorly crimped. Note: properly applied.

I have..

Soldering becomes an issue on shitboxes that run on n-1 cylinders(where n is the total nums of cyls) and or vehicles that have more in common with a paintshaker than not..

# ¿ May 14, 2019 01:35

cursedshitbox: May 20, 2012; Your rear-end wont survive my hammering.; Fun Shoe

That pin fix is extremely my fetish. Fuckin A nice.

# ¿ Jun 27, 2019 02:58

cursedshitbox: May 20, 2012; Your rear-end wont survive my hammering.; Fun Shoe

volley the fucker off some potholes and speed humps. see if it holds. Is there any tube bro-ey upgrades for it? Welds look fine, it'll hold. Nice catch on saving your tires too.

# ¿ Aug 16, 2019 04:39

The Something Awful Forums > Discussion > Automotive Insanity > Not the v6 you were expecting, enter the BITIMBO (and attex, etc)